KELIGROUT™ SIDEWALL INSTUCTIONS

Side Wall Instructions when using kelianchoring systems or re-bar with Keligrout.

1. If the anchor is to be removed later, dip entire embedded portion in Kelislip. Let dry at least 2 or 3 minutes before insertion.

2. Drill holes - preferably with air tools that will blow out hole. Holes must be dust free. Use compressed air.

3. Put Polyethylene stopper into hole.

4. Draw mixed resin from the can into the gun by drawing back the plunger.

5. Eject resin into the hole thru cross slotted plastic stopper.

6. Push anchor into the hole thru the stopper.

7. VERY IMPORTANT: The hole must be entirely filled - after anchor is inserted not before!! - with Keligrout. MAKE SURE THIS OCCURS!!!

8. Periodically (e.g. before lunch or when stopping operation for a while) lubricate the gun with a release agent (silicone, lps, Kelislip, etc.) Let dry before resuming use.

Stopper is pushed snug into drilled hole.

Resin is mixed. Gun draws mixed Keligrout in as plunger is pulled back.

Resin is extruded thru the crosscut stopper to back of hole. More than one hole may be done from each loading.

Anchor is pushed thru crosscuts displacing resin. Excess from weephole shows hole is filled with Keligrout.